Nanoleaf Helpdesk logo
Nanoleaf Helpdesk logo

All articles

How to Add an Extension to Your Nanoleaf Permanent Outdoor LightsUpdated 14 days ago

Nanoleaf Outdoor Permanent Lights can be extended up to 45m or 147ft. This guide will help you safely and effectively add a 5m / 16.4ft extension to your the setup. Follow the steps below to ensure a seamless setup.

Step 1: Unplug the Lights from Power

Before adding the extension, ensure that your lights are unplugged from the power source. This is crucial for your safety and to prevent any electrical issues.

Step 2: Unbox and Connect the Extension

  1. Carefully unbox your 5m extension lights.

  2. Connect it to the end of the existing lights.

  3. Make sure the connector is firmly tight, ensuring a secure connection.

Step 3: Plug the Lights Back into Power

Once the extension is connected, plug the string lights back into the power outlet.

Step 4: Verify Full Illumination

Check the entire length of the string, including the extension, to make sure all sections are lit up. Control the lights using controller buttons to ensure that the lights respond correctly. If any section of the lights doesn’t work, unplug them and check the connections.

Step 5: Install the Extension as Desired

With the lights working properly, you can now install the extension in your desired location. Arrange the lights to your preference, making sure they are installed with instructions mentioned in the user guide.


By following these steps, your permanent outdoor lights should now be successfully extended and ready to brighten up your outdoor space. If you are having an issue using your Nanoleaf Permanent Outdoor Lights? Reach out to Nanoleaf Support

Was this article helpful?
Yes
No