Nanoleaf Helpdesk logo
Nanoleaf Helpdesk logo

All collections

How to Use Multiple Control Squares in the Same Layout

If your Nanoleaf Canvas system has more than one Control Square, it is important to place one of them into Passive Mode so that squares are taking commands from only one of the Control Squares.

Setting your additional Control Squares into Passive Mode will cause it to behave like a normal square and receive commands from the active Control Square. This eliminates the chance of multiple Control Squares interfering with each other once connected to the same system.

Please enter this button sequence to enable Passive Mode on a Control Square: 

(Power →  + → -) x 3

Press the power button, then the + button, then the - button on the Control Square and repeat this sequence three times. 

Didn’t find what you were looking for? Contact us if you still need help. 

Was this article helpful?
Yes
No