Pairing Your Remote to Nanoleaf Light Panels Using the Rhythm Module
- iOS 9.2 or higher or Android 5.0 or higher
- Light Panels firmware 2.3.0 or higher
- A Nanoleaf Rhythm
Pairing Your Remote to the Nanoleaf Rhythm:
- Hold down the button on the Rhythm module until the Rhythm begins flashing blue (about 5-7 seconds)
- Hold your Remote next to the Rhythm module - the closer the better
- Once it has successfully paired, the Remote will flash green
- You can then configure the sides in the Nanoleaf App
To see an example of this, check out the video below (starts at 1:36 for pairing to the Rhythm)
Didn’t find what you are looking for? Contact us if you still need help.
Was this article helpful?