Nanoleaf Helpdesk logo
Nanoleaf Helpdesk logo

All collections

Nanoleaf Remote

9 articles

Articles

How to use your Nanoleaf Remote with Shapes and Elements

Minimum requirements: iOS 9.2 or higher or Android 5.0 or higher.   You can use Nanoleaf Remote with Shapes or Elements panels via Bluetooth. Please ensure to disable Thread Border Routing in the Nanoleaf App first before you begin with the pa

Pairing Your Remote to the Shapes

The Remote can be paired to the Nanoleaf Shapes in a few seconds by following the steps outlined below. The pairing process begins by holding the power button on the controller for 3-5 seconds.  The LEDs on the controller will begin to scroll (from

Pairing Your Remote to Nanoleaf Canvas

Minimum requirements: iOS 9.2 or higher or Android 5.0 or higher Canvas firmware 1.0.1 or higher    Pairing Your Remote to the Canvas Hold down the power button for 3-5 sec or until the button LEDs start scrolling Hold your Remote next to the Canv

Pairing Your Remote to Nanoleaf Light Panels Using the Rhythm Module

Minimum requirements: iOS 9.2 or higher or Android 5.0 or higher Light Panels firmware 2.3.0 or higher A Nanoleaf Rhythm  Pairing Your Remote to the Nanoleaf Rhythm: Hold down the button on the Rhythm module until the Rhythm begins flashing blue (

Pairing Your Remote Using HomeKit

Minimum requirements: iOS: iOS 11.3 or higher Light Panels firmware 2.3.0 or higher A HomeHub (AppleTV 4th Gen or higher; iPad with BLE 4.0 - newer than iPad 2; or HomePod) Pairing Your Remote in the Nanoleaf App:  Configure your HomeHub as per th

My Remote keeps flickering

This normally indicates that the voltage coming from the batteries is too low. Replacing the batteries for brand new ones will oftentimes resolve the issue. We would recommend to use high quality batteries to ensure a better performance.  If this doe

Programming Your Remote

To see configure the scenes to the sides of your Remote, please follow the instructions of the video below.  Didn’t find what you are looking for? Contact us if you still need help.

Resetting your Remote

Resetting your Remote will delete all pairings to HomeKit or your Nanoleaf Light Panels. You can achieve this by: Opening the Remote Using a pin, press in the Reset button on the Remote for 2 seconds. To see an example of this, check out the video

Remote Feature Requests

Have a request for something to add or improve on our Remote? Please let us know at [email protected] Didn’t find what you were looking for? Contact us if you still need help